28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58810J
2.REMOVE CONSOLE BOX ASSEMBLY
for Manual Transmission: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>REMOVAL)
w/ Refrigerated Cool Box: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>REMOVAL)
58286
3.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT
Remove the 4 screws and No. 1 shift and select lever boot.
33530F
4.REMOVE SHIFT LEVER ASSEMBLY
Detach the shift lever cap boot from the manual transmission.
Cover the shift lever cap with a cloth.
While pressing down on the shift lever cap, turn it counterclockwise, and then pull to remove the shift lever assembly.
| *1 | Shift Lever Cap |
| *a | Press Down |
| *b | Counterclockwise |
| *c | Pull out |
5.DRAIN MANUAL TRANSMISSION OIL
Remove the drain plug and gasket, and then drain the manual transmission oil.
Install a new gasket and the drain plug.
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
36179
7.REMOVE TRANSFER CASE LOWER PROTECTOR
Remove the 4 bolts and transfer case lower protector.
37140
8.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
37110
9.REMOVE PROPELLER SHAFT ASSEMBLY
31470
10.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
Remove the 2 bolts and clip, and then disconnect the release cylinder.
28100
11.REMOVE STARTER ASSEMBLY
for 2.2 kW Type: (See page Engine / Hybrid System>1KD-FTV (STARTING)>STARTER (for 2.2 kW Type)>REMOVAL)
for 2.7 kW Type: (See page Engine / Hybrid System>1KD-FTV (STARTING)>STARTER (for 2.7 kW Type)>REMOVAL)
51226A
12.REMOVE FRONT SUSPENSION MEMBER BRACKET LH
Remove the 4 bolts and front suspension member bracket LH.
51225B
13.REMOVE FRONT SUSPENSION MEMBER BRACKET RH
Remove the 4 bolts and front suspension member bracket RH.
51204
14.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Support the rear side of the manual transmission with a support stand.
Remove the 4 bolts from the No. 3 frame crossmember sub-assembly.
Remove the 4 nuts, 4 bolts and No. 3 frame crossmember sub-assembly.
12371
15.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
Remove the 4 bolts and rear No. 1 engine mounting insulator from the manual transmission.
16.DISCONNECT WIRE HARNESS
Detach the 5 wire harness clamps.
Disconnect the 2 connectors and wire harness.
36407
17.DISCONNECT TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY
Detach the breather hose clamp.
Disconnect the 3 breather hoses.
18.REMOVE MANUAL TRANSMISSION WITH TRANSFER
Remove the 9 bolts.
Remove the manual transmission with transfer.
33107
19.REMOVE TRANSMISSION UPPER COVER SUB-ASSEMBLY
Remove the 2 bolts and transmission upper cover sub-assembly.
36100
20.REMOVE TRANSFER ASSEMBLY