Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260747 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

When the ECM detects a cruise control main switch ON signal from the cruise control main switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.

·

The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Select the item below in the Active Test, and then check that the cruise control indicator light illuminates (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise control indicator light ON/OFF -

OK:

Cruise control indicator light turns on/off.




OK

2.READ VALUE USING INTELLIGENT TESTER

NG

2.READ VALUE USING INTELLIGENT TESTER
a.

Use the Data List to check if the cruise control main switch is functioning properly (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Main SW M-CPU Cruise control main switch (Main CPU) / ON or OFF ON: Cruise control main switch on
OFF: Cruise control main switch off
-

OK:

On screen, each item changes between ON and OFF according to above chart.


Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 2TR-FE) C
NG (for 1KD-FTV) D
NG (for 1GD-FTV) E



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

C

D

E