Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1615  Communication Error from Distance Control ECU to ECM  


DESCRIPTION

The driving support ECU receives information about the area in front of the vehicle from the millimeter wave radar sensor and then sends brake control demand signals (deceleration demand) and diagnosis signals, such as signal indicating the millimeter wave radar sensor assembly is dirty or malfunctioning, to the ECM.

DTC Code DTC Detection Condition Trouble Area
P1615 While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, communication data from the driving support ECU is logically inconsistent for 1 second.
·

Driving support ECU

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

When the driving support ECU or ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.CONFIRM DESIGNATION INFORMATION
a.

Confirm the designation information.

i.

Turn the ignition switch to ON.


ii.

Turn the cruise control switch on.


iii.

With the brake pedal depressed, push the cruise control switch to +RES 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

OK:

The skid control buzzer sounds (initialization is performed).


NOTICE:
·

Do not turn the light control switch on at this time as doing so causes the beam axis to deviate. If the light control switch is turned on by mistake, readjust the beam axis (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).

·

If initialization cannot be performed, first inspect the stop light switch circuit, cruise control switch circuit and skid control buzzer circuit.




iv.

Turn the ignition switch off.




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.


OK

END

NG

3.REPLACE DRIVING SUPPORT ECU
3.REPLACE DRIVING SUPPORT ECU
a.

Replace the driving support ECU (See page Engine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>REMOVAL).



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC P1615 is not output.


Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 1KD-FTV) C
NG (for 1GD-FTV) D



A

END (DRIVING SUPPORT ECU IS DEFECTIVE)

B

C

D