Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1616  Communication Error from ECM to Distance Control ECU  


DESCRIPTION

The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the driving support ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC Code DTC Detection Condition Trouble Area
P1616 While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, the ECM continuously receives a logical error signal from the driving support ECU for 1 second.
·

ECM

·

Driving support ECU



CAUTION / NOTICE / HINT

NOTICE:

When the driving support ECU or ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.CONFIRM DESIGNATION INFORMATION
a.

Confirm the designation information.

i.

Turn the ignition switch to ON.


ii.

Turn the cruise control switch on.


iii.

With the brake pedal depressed, push the cruise control switch to +RES 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

OK:

The skid control buzzer sounds (initialization is performed).


NOTICE:
·

Do not turn the light control switch on at this time as doing so causes the beam axis to deviate. If the light control switch is turned on by mistake, readjust the beam axis (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).

·

If initialization cannot be performed, first inspect the stop light switch circuit, cruise control switch circuit and skid control buzzer circuit.




iv.

Turn the ignition switch off.




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.


OK

END

NG

3.REPLACE ECM
3.REPLACE ECM
a.

for 1GR-FE:

Replace the ECM (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL).


b.

for 1KD-FTV:

Replace the ECM (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECM>REMOVAL).


c.

for 1GD-FTV:

Replace the ECM (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL).



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.


OK

END (ECM IS DEFECTIVE)

NG