In the dynamic radar cruise control system, the ECM and driving support ECU communicate with one another to control the system based on certain designation information. If the designation information of the ECM and driving support ECU are different or the driving support ECU is malfunctioning, this DTC is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1617 | While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, a designation signal from the ECM and a designation return signal from the driving support ECU do not match or the driving support ECU is malfunctioning for 1 second. | ·
Driving support ECU ·
ECM |
When the driving support ECU or ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).
Confirm the designation information.
Turn the ignition switch to ON.
Turn the cruise control switch on.
With the brake pedal depressed, push the cruise control switch to +RES 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.
The skid control buzzer sounds (initialization is performed).
Do not turn the light control switch on at this time as doing so causes the beam axis to deviate. If the light control switch is turned on by mistake, readjust the beam axis (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).
If initialization cannot be performed, first inspect the stop light switch circuit, cruise control switch circuit and skid control buzzer circuit.
Turn the ignition switch off.
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (31 mph) or more.
Turn the cruise control switch on.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1617 is not output.
OK
NG
Replace the driving support ECU (See page Engine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>REMOVAL).
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (31 mph) or more.
Turn the cruise control switch on.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1617 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 1KD-FTV) | C |
| NG (for 1GD-FTV) | D |
A
B
C
D