The skid control ECU sends signals, such as cruise control cancel demand signals and brake operation demand response signals, to the ECM when the dynamic radar cruise control system is in operation.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1630 | While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, the skid control ECU is logically inconsistent for 1 second. | ·
Hydraulic brake booster assembly (Skid control ECU) ·
ECM |
When the ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).
for LHD:
Replace the hydraulic brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>DISASSEMBLY).
for RHD:
Replace the hydraulic brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>DISASSEMBLY).
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (31 mph) or more.
Turn the cruise control switch on.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1630 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 1KD-FTV) | C |
| NG (for 1GD-FTV) | D |
A
B
C
D