The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the skid control ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1631 | While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, the ECM continuously receives a logical error signal from the skid control ECU for 1 second. | ·
ECM ·
Hydraulic brake booster assembly (Skid control ECU) |
When the ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).
for 1GR-FE:
Replace the ECM (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL).
for 1KD-FTV:
Replace the ECM (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECM>REMOVAL).
for 1GD-FTV:
Replace the ECM (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL).
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (31 mph) or more.
Turn the cruise control switch on.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1631 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
B
C