Home › Power Source / Network › POWER DISTRIBUTION › POWER MANAGEMENT CONTROL ECU › 2015.06–2017.08
RM27T0E _57 Power Source / Network _053728 POWER DISTRIBUTION _0261029 POWER MANAGEMENT CONTROL ECU A

POWER DISTRIBUTION  POWER MANAGEMENT CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 67910 2.REMOVE DOOR SCUFF PLATE ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


a.

for 5 Door:

Remove the door scuff plate assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).


b.

for 3 Door:

Remove the door scuff plate assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>REMOVAL).


Hide 62111C 3.REMOVE COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure described for the LH side.


a.

for 5 Door:

Remove the cowl side trim board LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).


b.

for 3 Door:

Remove the cowl side trim board LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>REMOVAL).


Hide 55607 4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 82877 9.REMOVE ECU INTEGRATION BOX RH

B240503

a.

Disconnect all the connectors.


b.

Detach the clamp.


c.

Remove the 2 nuts, bolt and ECU integration box RH.


Hide 89681A 10.REMOVE POWER MANAGEMENT CONTROL ECU

B241824

a.

Detach the 2 claws and remove the power management control ECU.