Home › Drivetrain › A750F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV) › 2015.06–2017.08
RM27T0E _52 Drivetrain _053697 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0260766 AUTOMATIC TRANSMISSION SYSTEM(for 1KD-FTV) J

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1KD-FTV)  ECU Power Source Circuit  


DESCRIPTION

When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK TCM (TCM - BODY GROUND)
a.
U169986E02
1.313,1.958 1.542,2.646 false 0.865,0.385 1.24,0.615 0.375,0.229 10 false G69 0.115,0.073 0.396,0.25 0.281,0.177 10 false *a 1.354,2.698 1.906,2.854 0.552,0.156 10 false 1 (E1)

Disconnect the G69 TCM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G69-1 (E1) - Body ground Always Below 1 Ω


Text in Illustration
*a Rear view of wire harness connector
(to TCM)



OK

2.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - TCM)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - TCM)
a.

Disconnect the No. 1 integration relay 1A connector.


b.

Disconnect the G70 TCM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1A-4 - G70-6 (IG2) Always Below 1 Ω
1A-4 or G70-6 (IG2) - Body ground Always 10 kΩ or higher




OK

GO TO ECD SYSTEM (ECM POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR