1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
62111C
4.REMOVE COWL SIDE TRIM BOARD RH
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH
55461A
6.REMOVE INSTRUMENT PANEL ORNAMENT
55607
7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55550
8.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89533
9.REMOVE 4 WHEEL DRIVE CONTROL ECU
Disconnect the 2 connectors.
Remove the bolt and 4 wheel drive control ECU.