Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
47319F
5.DISCONNECT REAR FLEXIBLE HOSE LH
89546
6.REMOVE REAR SPEED SENSOR LH
7.REMOVE PARKING BRAKE ASSEMBLY
Remove the parking brake assembly (See page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>DISASSEMBLY).
42312
8.REMOVE REAR AXLE SHAFT WITH PARKING BRAKE PLATE LH
Remove the 4 nuts and rear axle shaft with parking brake plate.
Remove the O-ring.
42312C
9.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, remove the rear axle shaft oil seal.