Before removal, Be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR WHEEL LH
76608
3.REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH
48978
4.REMOVE HEIGHT CONTROL COMPRESSOR COVER
52046A
5.REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)
48925
6.REMOVE HEIGHT CONTROL FILTER
48982
7.DISCONNECT NO. 2 HEIGHT CONTROL TUBE
48910B
8.REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY
Disconnect the connector.
Detach the 3 clamps.
Detach the No. 2 height control tube.
Disconnect the connector.
Detach the clamp.
Remove the 3 bolts and height control compressor.
48950
9.REMOVE HEIGHT CONTROL DRYER ASSEMBLY
Disconnect the No. 2 height control tube (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).
For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.
Remove the bolt and height control dryer from the height control compressor.
Remove the O-ring.