89408D
1.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Install the height control sensor with the 2 bolts.
| *1 | Matchmark |
Replace the rear height control sensor sub-assembly with a new one if it is dropped.
Align the matchmarks on the link and bracket.
Connect the sensor link with the nut.
Connect the connector, and then attach the connector.
Attach the clamp.
2.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
3.INSTALL REAR WHEEL
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).