Home › Suspension › SUSPENSION CONTROL › SUSPENSION CONTROL ECU › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260877 SUSPENSION CONTROL ECU A

SUSPENSION CONTROL  SUSPENSION CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)

Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

Hide 89293 4.REMOVE SUSPENSION CONTROL ECU

a.
C212880

Disconnect the 3 connectors.


b.

Remove the 2 bolts and suspension control ECU.

NOTICE:

Replace the suspension control ECU with a new one if it is dropped.