Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261095 KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 67920 2.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)

Hide 67910 3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

Hide 62112 4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)

Hide 62111C 5.REMOVE COWL SIDE TRIM BOARD RH (for RHD)

Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55318C 7.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

Hide 55317A 8.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

Hide 55471A 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 55476C 10.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55480D 11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55045 12.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 73900 13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.
B238327

Remove the 4 bolts and airbag assembly.


b.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.