Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR › 2015.06–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260879 FRONT ACCELERATION SENSOR A

SUSPENSION CONTROL  FRONT ACCELERATION SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55550 2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 89191A 4.REMOVE FRONT ACCELERATION SENSOR

a.
C212876

Disconnect the connector from the front acceleration sensor.


b.

Remove the bolt and acceleration sensor.

NOTICE:

Replace the front acceleration sensor with a new one if it is dropped.