89269A
1.INSTALL SUSPENSION CONTROL BRACKET LH
Using SST, install the bracket with the nut.
89241B
2.INSTALL ABSORBER CONTROL ACTUATOR LH
Using a hexagon wrench (4 mm), install the absorber control actuator with the 2 hexagon socket head cap bolts.
Replace the absorber control actuator with a new one if it is dropped.
Connect the connector, and then attach the 3 clamps.
Securely connect the connector.
3.INSTALL FRONT WHEEL
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).