The stabilizer control ECU receives steering angle information from the steering angle sensor via CAN communication.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1884/84 | Either condition is met:
·
The stabilizer control ECU receives an error signal from the steering sensor for 5 seconds. ·
A steering angle sensor BAT terminal open circuit malfunction signal is continuously received for 5 seconds. |
·
Steering angle sensor (Spiral cable sub-assembly) ·
Steering angle sensor circuit ·
Stabilizer control ECU |
If DTC U0126/71 and C1884/84 are output at the same time, perform the inspection necessary for the CAN communication system first (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>U0100/71).
Check for steering angle sensor malfunction DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Perform a road test.
Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B