Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2015.06–2017.08
RM27T0E _53 Suspension _053710 TIRE PRESSURE MONITORING _0260907 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  Tire Pressure Warning Light Circuit  


DESCRIPTION

If the tire pressure warning ECU and receiver detects a disconnected connector or an open circuit between the tire pressure warning ECU and receiver and combination meter assembly, the tire pressure warning light blinks for 1 minute, and then remains on after the ignition switch ON.

WIRING DIAGRAM

C171956E17
5.604,0.875 5.75,1.042 0.146,0.167 10 false 5 5.906,1.021 6.302,1.198 0.396,0.177 10 false IND 5.375,1.76 7.156,2.24 1.781,0.479 10 false Tire Pressure Warning ECU and Receiver 1.563,0.833 1.813,1.042 0.25,0.208 10 false 16 0.354,1.875 2.302,2.198 1.948,0.323 10 false Combination Meter Assembly 5.375,1.563 5.781,1.781 0.406,0.219 10 false R41 0.354,1.677 0.667,1.865 0.313,0.188 10 false G7 1.052,0.99 1.417,1.156 0.365,0.167 10 false TIRE

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECU)
a.

Disconnect the tire pressure warning ECU and receiver R41 connector.


b.

Disconnect the combination meter assembly G7 connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R41-5 (IND) - G7-16 (TIRE) Always Below 1 Ω
R41-5 (IND) or G7-16 (TIRE) - Body ground Always 10 kΩ or higher




OK

2.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


f.

Check the condition of the tire pressure warning light by using the GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON Confirm that the vehicle is stopped with the engine idling.

OK:

The tire pressure warning light turns on or off in accordance with the GTS operation.




OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG