The skid control ECU receives signals from the acceleration sensor via the CAN communication system.
The acceleration sensor detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the acceleration sensor and the CAN communication system, DTC U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
This DTC is also stored when calibration is not completed.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1419 | A data malfunction signal is received from the acceleration sensor. | Acceleration sensor |
Refer to DTCs C1243 and C1245 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1243).
When replacing the acceleration sensor, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
When DTC U0124 is output together with DTC C1419, inspect and repair the trouble areas indicated by DTC U0124 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>U0073).
Replace the acceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>REMOVAL).
NEXT