28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58901A
2.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
for Automatic Transmission:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Automatic Transmission)>REMOVAL)
for Manual Transmission:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>REMOVAL)
w/ Refrigerated Cool Box:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>REMOVAL)
for Bench Seat Type:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Bench Seat Type)>REMOVAL)
3.REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type)
58530J
4.REMOVE CENTER FLOOR CARPET ASSEMBLY (for Bench Seat Type)
89183A
5.REMOVE YAW RATE AND ACCELERATION SENSOR
Remove the 2 bolts and yaw rate and acceleration sensor.
| *A | for Automatic Transmission | *B | for Manual Transmission |
Disconnect the connector.
for Automatic Transmission:
Detach the clamp from the sensor bracket.