The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1421 | Either condition is met:
1.
With the IG1 terminal voltage between 9.5 and 17.4 V, the VCM terminal voltage is not between 4.4 and 5.6 V for 1.2 seconds or more. 2.
When the VCM terminal voltage is between 4.8 and 5.2 V, the PMC terminal voltage is not between 0.19 and 4.57 V for 1.2 seconds or more. |
Brake actuator assembly (Master cylinder pressure sensor) |
| C1281 | Stored only during test mode. | Brake actuator assembly (Master cylinder pressure sensor) |
| C1423 | The PMC terminal voltage is below 0.27 V for 5 seconds or more. | Brake actuator assembly (Master cylinder pressure sensor) |
| C1424 | One of the following conditions is met:
1.
Noise occurs in the PMC terminal signal 7 times or more within 5 seconds. 2.
When the vehicle speed drops from 40 km/h (25 mph) to 10 km/h (6 mph), the master cylinder pressure does not change by at least 0.048 MPa. 3.
At a vehicle speed of 7 km/h (4.3 mph) or more, the PMC terminal voltage is between 0.86 and 1.0 V and the master cylinder pressure does not change by at least 0.048 MPa for 60 seconds or more. 4.
At a vehicle speed of 7 km/h (4.3 mph) or more, the PMC terminal voltage is 1.0 V or more and the master cylinder pressure does not change by at least 0.048 MPa for 30 seconds or more. 5.
At a vehicle speed of 7 km/h (4.3 mph) or more with the stop switch on, a state in which the pressure sensor input value is sufficiently more than the estimated master pressure continues for 1 second or more and this state occurs 5 or more times each time the ignition switch is turned to ON, and this occurs 8 or more times consecutively. |
Brake actuator assembly (Master cylinder pressure sensor) |
Refer to DTC C1425 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1425).
When replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
Replace the brake actuator assembly (master cylinder pressure sensor) (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL).
NEXT