The solenoid turns on when signals are received from the skid control ECU and controls the pressure acting on the wheel cylinders, thus controlling braking force.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C0226 | An open or short circuit in the SFRH or SFRR circuit continues for 0.05 seconds or more. | ·
SFRH or SFRR circuit ·
Master cylinder solenoid |
| C0236 | An open or short circuit in the SFLH or SFLR circuit continues for 0.05 seconds or more. | ·
SFLH or SFLR circuit ·
Master cylinder solenoid |
| C0246 | An open or short circuit in the SRRH or SRRR circuit continues for 0.05 seconds or more. | ·
SRRH or SRRR circuit ·
Master cylinder solenoid |
| C0256 | An open or short circuit in the SRLH or SRLR circuit continues for 0.05 seconds or more. | ·
SRLH or SRLR circuit ·
Master cylinder solenoid |
| C1225 | An open or short circuit in the SMCF circuit continues for 0.05 seconds or more. | ·
SMCF circuit ·
Master cylinder solenoid |
| C1226 | An open or short circuit in the SREA circuit continues for 0.05 seconds or more. | ·
SREA circuit ·
Master cylinder solenoid |
| C1227 | An open or short circuit in the SREC circuit continues for 0.05 seconds or more. | ·
SREC circuit ·
Master cylinder solenoid |
| C1228 | An open or short circuit in the STR circuit continues for 0.05 seconds or more. | ·
STR circuit ·
Master cylinder solenoid |
When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).
These codes are stored when a problem is detected in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspections and solenoid unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C