Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260911 VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster)  C1257  Power Supply Drive Circuit  


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC Code DTC Detection Condition Trouble Area
C1257 There is an open in the motor system circuit (motor input circuit). Master cylinder solenoid (Skid control ECU)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).


PROCEDURE

1.CHECK PUMP MOTOR OPERATION
a.

Turn the ignition switch off.


b.

Disconnect the A7 skid control ECU connector.


c.

Depress the brake pedal more than 40 times.


d.

Turn the ignition switch to ON.


e.

Check pump motor operation.

OK:

Pump motor operates normally.


Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

2.RECONFIRM DTC

B

C

2.RECONFIRM DTC
a.

Turn the ignition switch off.


b.

Reconnect the A7 skid control ECU connector.


c.

Turn the ignition switch to ON.



e.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

C