Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260911 VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster)  C120A  ECU Initial Setting Incomplete  


DESCRIPTION

The master cylinder solenoid (skid control ECU) records information on whether there is a kinetic dynamic suspension system or not.

w/ Downhill Assist Control or w/ Crawl Control:

When the master cylinder solenoid (skid control ECU) is replaced, the master cylinder solenoid (skid control ECU) must be informed that the vehicle is equipped with downhill assist control and/or crawl control.

DTC Code DTC Detection Condition Trouble Area
C120A Either condition is met:
·

The master cylinder solenoid is not informed that the vehicle is equipped with downhill assist control or crawl control and downhill assist control or crawl control operates.

·

There is no information on whether there is a kinetic dynamic suspension system or not.


Calibration not performed

PROCEDURE

1.PERFORM CALIBRATION
a.

Perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).

NOTICE:

If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed.




NEXT

2.CHECK DTC
2.CHECK DTC
a.

Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

3.CHECK TEST MODE DTC

B

END

3.CHECK TEST MODE DTC
a.

Switch the vehicle to test mode, perform the downhill assist control switch or crawl switch signal check, and then check that Test Mode (Signal Check) DTC C1379 is cleared (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>TEST MODE PROCEDURE).

Result
Result Proceed to
Test Mode DTC C1379 is not cleared A
Test Mode DTC C1379 is cleared B



A

B