| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1268 | The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via the CAN. | ·
Transfer system ·
Brake actuator assembly (Skid control ECU) |
When replacing the brake actuator assembly, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CALIBRATION).
Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
There are no problems with the transfer system.
OK
NG
Shift the transfer to L4, drive the vehicle, and then check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)