Home › Drivetrain › VF4BM (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › 2015.06–2017.08
RM27T0E _52 Drivetrain _053703 VF4BM TRANSFER / 4WD / AWD _0260838 TRANSFER SYSTEM T

VF4BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Transfer System
Symptom Suspected Area See page
Noise Oil (Level low) (Click here)
Oil (Wrong) (Click here)
Transfer faulty (Click here)
Oil leakage Oil (Level too high) (Click here)
Gasket (Damaged) (Click here)
Oil seal (Worn or damaged) (Click here)
O-ring (Worn or damaged) (Click here)
Switch from HIGH to LOW is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
Transfer position switch (w/o Combination Switch) (Click here)
Transfer position switch (w/ Combination Switch) (Click here)
4 wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from LOW to HIGH is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
Transfer position switch (w/o Combination Switch) (Click here)
Transfer position switch (w/ Combination Switch) (Click here)
4 wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from FREE to LOCK is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
Transfer position switch (for 2TR-FE, 5L-E) (Click here)
Center differential lock switch (w/o Combination Switch) (Click here)
Center differential lock switch (w/ Combination Switch) (Click here)
4 wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from LOCK to FREE is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
Transfer position switch (for 2TR-FE, 5L-E) (Click here)
Center differential lock switch (w/o Combination Switch) (Click here)
Center differential lock switch (w/ Combination Switch) (Click here)
4 wheel drive control ECU (Click here)
Transfer faulty (Click here)
4LO indicator light does not come on Harness or connector (Click here)
Combination meter (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
4 wheel drive control ECU (Click here)
Transfer position switch (w/o Combination Switch) (Click here)
Transfer position switch (w/ Combination Switch) (Click here)
Transfer shift actuator assembly (Click here)
4LO indicator light remains on 4 wheel drive control ECU (Click here)
Transfer position switch (w/o Combination Switch) (Click here)
Transfer position switch (w/ Combination Switch) (Click here)
Combination meter (Click here)
Center differential lock indicator light does not come on Harness or connector (Click here)
Combination meter (Click here)
CAN communication system (for LHD with Entry and Start System) (Click here)
CAN communication system (for LHD without Entry and Start System) (Click here)
CAN communication system (for RHD with Entry and Start System) (Click here)
CAN communication system (for RHD without Entry and Start System) (Click here)
4 wheel drive control ECU (Click here)
Transfer position switch (for 2TR-FE, 5L-E) (Click here)
Center differential lock switch (w/o Combination Switch) (Click here)
Center differential lock switch (w/ Combination Switch) (Click here)
Transfer shift actuator assembly (Click here)
Center differential lock indicator light remains on (Blinking) 4 wheel drive control ECU (Click here)
Transfer position switch (for 2TR-FE, 5L-E) (Click here)
Center differential lock switch (w/o Combination Switch) (Click here)
Center differential lock switch (w/ Combination Switch) (Click here)
Combination meter (Click here)