POWER ASSIST SYSTEMS POWER STEERING SYSTEM(w/ VSC) DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
Power Steering System
DTC Code
Detection Item
Return-to-normal
See page
C1541
Vehicle Speed Signal
After normal confirmation
()
C1544
High Engine Revolution Signal
After normal confirmation
()
C15F0
VFC Solenoid Circuit
Ignition switch turned to ON again
()
C15F1
Steering Angle Sensor Circuit
After normal confirmation
()
U0100
Lost Communication with ECM / PCM "A"
After CAN communication system returns to normal condition or ignition switch turned to ON again
()
U0126
Lost Communication with Steering Angle Sensor Module
After CAN communication system returns to normal condition or ignition switch turned to ON again
()
U0129
Lost Communication with Brake System Control Module
After CAN communication system returns to normal condition or ignition switch turned to ON again