The power steering ECU is connected to the combination meter via CAN communication. If the power steering ECU detects a malfunction, the power steering warning light comes on. At this time, the vehicle enters fail-safe mode.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check for DTCs of the CAN communication system.
for LHD with Entry and Start System:
Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>DIAGNOSIS SYSTEM).
for LHD without Entry and Start System:
Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>DIAGNOSIS SYSTEM).
for RHD with Entry and Start System:
Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>DIAGNOSIS SYSTEM).
for RHD without Entry and Start System:
Refer to the following procedures (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>DIAGNOSIS SYSTEM).
| Result | Proceed to | |
|---|---|---|
| DTC is not output. | A | |
| DTC is output. | for LHD with Entry and Start System | B |
| for LHD without Entry and Start System | C | |
| for RHD with Entry and Start System | D | |
| for RHD without Entry and Start System | E | |
A
B
C
D
E
Disconnect the power steering ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G46-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G46-3 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Power Steering ECU) |
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Perform the Active Test of the combination meter using the intelligent tester (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| PPS Indicator | Power steering warning light | ON or OFF | Perform the test with the vehicle stopped and the engine idling. |
Check that the power steering warning light operates in accordance with the Active Test.
Reconnect the connectors and restore the vehicle to its previous condition before checking the combination meter.
The power steering warning light turns on and off in accordance with the intelligent tester operation.
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)