Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU › 2015.06–2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260950 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55607 4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 89650 10.REMOVE POWER STEERING ECU ASSEMBLY

a.
C218276

Using a screwdriver, detach the 2 claws and remove the power steering ECU assembly.

HINT:

Tape the screwdriver tip before use.