When using a vise, do not overtighten it.
When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GR-FE)>COMPONENTS).
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE FRONT WHEEL RH
53736
3.REMOVE FRONT FENDER APRON SEAL RH
11259
4.REMOVE V-BANK COVER SUB-ASSEMBLY
5.REMOVE AIR CLEANER CAP AND HOSE
17801
6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
7.REMOVE AIR CLEANER CASE
16361A
8.REMOVE FAN AND GENERATOR V BELT
9.DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR
Disconnect the 2 connectors.
44348A
10.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
Slide the clip and disconnect the oil reservoir to pump hose from the vane pump.
44410
11.DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and disconnect the pressure feed tube.
Remove the gasket.
44310
12.REMOVE VANE PUMP ASSEMBLY
Remove the bolt and harness bracket.
Remove the 2 bolts and vane pump.