The ECU power source circuit supplies positive voltage to the multiplex tilt and telescopic ECU.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| B2620 | The ECU power source voltage drops to 8 V or less for 10 seconds or more. | ·
ECU-B fuse ·
Harness or connector ·
Multiplex tilt and telescopic ECU |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G116 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G116-9 (ECUB) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
OK
NG
OK
NG