Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
3.REMOVE NO. 3 STEERING WHEEL LOWER COVER
45186
4.REMOVE NO. 2 STEERING WHEEL LOWER COVER
5.REMOVE STEERING PAD
45116
6.REMOVE NO. 1 STEERING WHEEL ORNAMENT
Remove the 2 screws.
Detach the claw, 3 guide pins and then remove the ornament.
45117
7.REMOVE NO. 2 STEERING WHEEL ORNAMENT
Remove the 2 screws.
Detach the claw, 3 guide pins and then remove the ornament.
Refer to "Remove No. 1 Steering Wheel Ornament".
84250A
8.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Disconnect the connector.
Remove the 4 screws.
Detach the 2 claws, 6 guide pins and then remove the steering pad switch assembly.
Refer to "Remove No. 1 Steering Wheel Ornament".
84244B
9.REMOVE STEERING PAD SWITCH RH (w/ Steering Pad Switch)
Disconnect the connector.
Remove the 2 screws.
Detach the claw, 3 guide pins and steering pad switch RH.
Refer to "Remove No. 1 Steering Wheel Ornament".
84632
10.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
55910E
11.REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)
45100
12.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Using SST, remove the steering wheel assembly.