Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260975 INSTRUMENT PANEL SPEAKER A

AUDIO / VIDEO  INSTRUMENT PANEL SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55408F 6.REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

Hide 86160P 7.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

a.
B239150

Remove the 2 screws.


b.

Disconnect the connector and remove the front No. 2 speaker assembly.

NOTICE:

Do not touch the cone of the speaker.



Hide 86140A 8.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)

Hide 55421B 9.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL

Hide 86160L 10.REMOVE FRONT NO. 4 SPEAKER ASSEMBLY

a.
B239154

Remove the 2 screws.


b.

Disconnect the connector and remove the front No. 4 speaker assembly.

NOTICE:

Do not touch the cone of the speaker.