1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
for 5 Door:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL)
for 3 Door:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>REMOVAL)
86300
4.REMOVE HOLDER ANTENNA ASSEMBLY (for 5 Door)
for Diversity:
Disconnect the 3 connectors.
Remove the bolt and holder antenna shown in the part of the illustration labeled A.
Detach the clamp and remove the holder antenna shown in the part of the illustration labeled B.
for Non Diversity:
Disconnect the 2 connectors.
Remove the bolt and holder antenna.
86300
5.REMOVE HOLDER ANTENNA ASSEMBLY (for 3 Door)
for Diversity:
Disconnect the 3 connectors.
Detach the clamp and remove the bolt and holder antenna shown in the part of the illustration labeled A.
Detach the 4 clamps and remove the bolt and holder antenna shown in the part of the illustration labeled B.
for Non Diversity:
Disconnect the 2 connectors.
Detach the clamp and remove the bolt and holder antenna.