Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)
for LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>REMOVAL).
for RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>REMOVAL).
67920
4.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
67910
5.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure described for the LH side.
62112
6.REMOVE COWL SIDE TRIM BOARD LH
62111C
7.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
62312B
8.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
9.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure described for the LH side.
74616C
10.REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH
74615E
11.REMOVE FRONT NO. 1 ASSIST GRIP PLUG RH
Use the same procedure described for the LH side.
74611F
12.REMOVE NO. 1 ASSIST GRIP
62212
13.REMOVE FRONT PILLAR GARNISH LH
62211
14.REMOVE FRONT PILLAR GARNISH RH
Use the same procedure described for the LH side.
64910M
15.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Remove the tonneau cover.
58649C
16.REMOVE MAT SET PLATE COVER
Use the same procedure for all mat set plate covers.
Using a screwdriver, detach the 2 claws and remove the mat set plate cover.
Tape the screwdriver tip before use.
| *1 | Protective tape |
58574A
17.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
Remove the 5 screws.
Detach the 6 claws and remove the rear floor mat rear support plate.
62538E
18.REMOVE QUARTER TRIM COVER HOLE LH
Detach the 2 claws and 2 guides and remove the quarter trim cover hole.
62538C
19.REMOVE QUARTER TRIM COVER HOLE RH
Use the same procedure described for the LH side.
58570C
20.REMOVE REAR FLOOR CARPET ASSEMBLY
Remove the rear floor carpet.
64725D
21.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Use the same procedure for the other No. 1 luggage compartment trim hook.
Remove the luggage compartment trim hook by turning it clockwise.
64937A
22.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
Use the same procedure for the other tonneau cover holder cap.
Using a screwdriver, detach the 2 claws and remove the tonneau cover holder cap.
Tape the screwdriver tip before use.
| *1 | Protective tape |
64712F
23.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
Use the same procedure for the other front deck side trim cover.
Using a screwdriver, detach the 2 claws and remove the front deck side trim cover.
Tape the screwdriver tip before use.
| *1 | Protective tape |
62596D
24.REMOVE QUARTER TRIM POCKET TRAY
Put protective tape around the quarter trim pocket tray.
Using a screwdriver, detach the 6 claws and 2 guides, and remove the quarter trim pocket tray.
Tape the screwdriver tip before use.
| *1 | Protective tape |
73233
25.REMOVE OUTER LAP BELT ANCHOR COVER
Use the same procedure for the other outer lap belt anchor cover.
Detach the 3 claws and remove the outer lap belt anchor cover.
64740C
26.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips and remove the deck trim side panel.
64730B
27.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips.
Disconnect the connector and remove the deck trim side panel.
62520P
28.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
Move the front shoulder belt anchor adjuster to the lowest position.
Remove the bolt.
Detach the 2 clips and 2 guides.
Pass the front seat outer belt floor anchor through the front quarter trim panel and remove the front quarter trim panel.
62510P
29.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
Use the same procedure described for the LH side.
62640P
30.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
Detach the 7 clips.
Detach the 4 claws and 2 guides, pass the rear No. 1 seat belt floor anchor through the rear quarter trim panel and remove the rear quarter trim panel.
62630P
31.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH
Use the same procedure described for the LH side.
74610A
32.REMOVE ASSIST GRIP SUB-ASSEMBLY
74610U
33.REMOVE REAR ASSIST GRIP ASSEMBLY LH
74610V
34.REMOVE REAR ASSIST GRIP ASSEMBLY RH
Use the same procedure described for the LH side.
74318
35.REMOVE VISOR BRACKET COVER LH
74317
36.REMOVE VISOR BRACKET COVER RH
Use the same procedure described for the LH side.
74320
37.REMOVE VISOR ASSEMBLY LH
74310
38.REMOVE VISOR ASSEMBLY RH
Use the same procedure described for the LH side.
74348
39.REMOVE VISOR HOLDER
81260A
40.REMOVE MAP LIGHT ASSEMBLY
89943
41.REMOVE RAIN SENSOR COVER (w/ Rain Sensor)
87834
42.REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
81240
43.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
Remove the No. 1 room light assembly (See page Vehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Center)>REMOVAL).
81240D
44.REMOVE NO. 2 ROOM LIGHT ASSEMBLY
Remove the No. 2 room light assembly (See page Vehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Rear)>REMOVAL).
62432B
45.REMOVE NO. 1 ROOF SIDE RAIL GARNISH LH
Detach the 5 clips.
Cut off the 5 clips and remove the roof side rail garnish LH.
| *a | Cut Off Position |
Remove the 5 clips from the vehicle body.
62431B
46.REMOVE NO. 1 ROOF SIDE RAIL GARNISH RH
Use the same procedure described for the LH side.
63310
47.REMOVE ROOF HEADLINING ASSEMBLY
w/ EC Mirror:
Disconnect the inner mirror connector.
w/ Rain Sensor:
Disconnect the rain sensor connector.
w/ Sliding Roof:
Disconnect the drive gear connector.
w/ Digital Audio Broadcasting Antenna:
Disconnect the connector and detach the wire harness clamp.
Disconnect the 2 connectors and detach the 3 clamps from the front pillar LH.
Remove the bolt.
Disconnect the 2 connectors and detach the 3 clamps from the front pillar RH.
Disconnect the connector and detach the 3 clamps from the rear pillar LH.
Disconnect the connector and detach the 4 clamps from the rear pillar RH.
w/o Sliding Roof:
Detach the 2 clips.
w/ Sliding Roof:
Detach the 2 clips, 2 guides and 8 fasteners.
| *1 | Guide |
| *2 | Fastener |
Remove the roof headlining from the back door as shown in the illustration.
Be careful not to damage the roof headlining when removing it.
73024
48.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH
Detach the 4 claws of the front shoulder belt anchor plate and slide the front shoulder belt anchor plate in the direction of the arrow to remove it.
73023
49.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
66425A
50.REMOVE REAR NO. 2 SIDE RAIL SPACER LH
Remove the clip.
Detach the 4 claws and remove the rear side rail spacer.
66415A
51.REMOVE REAR NO. 2 SIDE RAIL SPACER RH
Use the same procedure described for the LH side.
64746F
52.REMOVE DECK SIDE TRIM CUP HOLDER LH
Detach the 4 claws and remove the deck side trim cup holder.
64745H
53.REMOVE DECK SIDE TRIM CUP HOLDER RH
Use the same procedure described for the LH side.
73372
54.REMOVE REAR SEAT SHOULDER BELT HANGER LH
Detach the claw and guide and remove the rear seat shoulder belt hanger.
73371
55.REMOVE REAR SEAT SHOULDER BELT HANGER RH
Use the same procedure described for the LH side.
62627B
56.REMOVE QUARTER TRIM COVER
Use the same procedure for the other quarter trim cover.
Detach the 2 claws and remove the quarter trim cover.
64766B
57.REMOVE QUARTER TRIM JACK COVER (w/ Spare Tire)
Detach the 7 claws and 3 guides and remove the quarter trim jack cover.
64714C
58.REMOVE DECK SIDE TRIM COVER RH (w/o Spare Tire)
Turn the 2 knobs and release the lock.
Detach the 7 claws and 3 guides and remove the deck side trim cover.