Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
86163
1.INSTALL NO. 2 SPEAKER BRACKET
Align the positioning pin of the speaker bracket with the hole and temporarily install the bracket.
Install the No. 2 speaker bracket with the 3 bolts.
Do not touch the cone of the speaker.
Attach the clamp.
86160C
2.INSTALL REAR SPEAKER SET
Temporarily install the speaker by attaching the 2 claws of the speaker to the door panel.
Install the speaker with the 3 screws.
Do not touch the cone of the speaker.
Connect the connector.
64740C
3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
73233
4.INSTALL OUTER LAP BELT ANCHOR COVER
62596D
5.INSTALL QUARTER TRIM POCKET TRAY
64712F
6.INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
64937A
7.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64725D
8.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
58570C
9.INSTALL REAR FLOOR CARPET ASSEMBLY
62538E
10.INSTALL QUARTER TRIM COVER HOLE LH
58574A
11.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
58649C
12.INSTALL MAT SET PLATE COVER
64910M
13.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
62312B
14.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
67920
15.INSTALL DOOR SCUFF PLATE ASSEMBLY LH
16.INSTALL REAR NO. 1 SEAT ASSEMBLY
for 60/40 Split Tumble Seat Type LH Side:
for 60/40 Split Tumble Seat Type RH Side:
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).