Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2015.06–2016.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260992 NAVIGATION SYSTEM(for Radio and Display Type) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1579 Telephone microphone signal is lost.
·

Radio and display receiver assembly

·

Map light assembly

·

Telephone microphone assembly

·

Harness or connector



WIRING DIAGRAM

B360077E06
0.746,2.653 2.562,2.850 1.817,0.197 10 Map Light Assembly 0.781,0.587 1.556,1.270 0.775,0.683 10 Telephone Microphone Assembly 1.811,0.847 2.259,1.006 0.448,0.159 10 MCO+ 1.818,1.237 2.231,1.396 0.413,0.159 10 MCO- 1.774,0.422 2.231,0.581 0.456,0.159 10 MACC 4.732,1.852 5.344,2.011 0.613,0.159 10 * 3.015,1.859 3.628,2.018 0.613,0.159 10 * 0.322,3.386 2.379,3.545 2.057,0.159 10 *: Shielded 2.311,2.038 2.560,2.197 0.249,0.159 10 14 2.311,0.855 2.523,1.014 0.211,0.159 10 12 2.311,1.244 2.523,1.403 0.211,0.159 10 13 2.311,0.438 2.560,0.597 0.249,0.159 10 11 5.469,2.038 5.597,2.197 0.128,0.159 10 6 5.396,1.637 5.584,1.796 0.188,0.159 10 18 5.469,0.855 5.579,1.014 0.110,0.159 10 5 5.401,1.244 5.584,1.403 0.183,0.159 10 19 5.469,0.438 5.597,0.597 0.128,0.159 10 4 5.534,2.637 6.818,2.995 1.284,0.358 10 Radio and Display Receiver Assembly 0.76,2.487 1.244,2.698 0.484,0.211 10 W7 5.534,2.473 5.957,2.648 0.423,0.175 10 H51 5.711,0.95 6.151,1.109 0.441,0.159 10 MIN+ 5.711,1.327 6.151,1.486 0.441,0.159 10 MIN- 5.711,1.724 6.195,1.884 0.485,0.159 10 SGND 5.711,0.525 6.151,0.684 0.441,0.159 10 MACC 1.83,2.031 2.231,2.190 0.401,0.159 10 SNS2 5.711,2.121 6.151,2.281 0.441,0.159 10 SNS2 3.825,1.866 4.438,2.025 0.613,0.159 10 *

PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
U170703E01
2.415,1.802 2.781,1.976 0.365,0.174 10 MIN- 2.053,1.298 2.165,1.896 2.165,1.896 2.391,1.896 false 2.658,1.569 3.101,1.743 0.443,0.174 10 SGND 2.179,1.307 2.408,1.663 2.408,1.663 2.634,1.663 false 2.744,0.273 3.187,0.447 0.443,0.174 10 MACC 0.067,0.04 0.310,0.214 0.242,0.174 10 *a 0.212,0.98 0.701,1.154 0.489,0.174 10 H51 2.194,1.052 2.444,0.367 2.444,0.367 2.72,0.367 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H51-18 (SGND) - Body ground Always Below 1 Ω
H51-19 (MIN-) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H51-4 (MACC) - Body ground Engine switch on (ACC) 4 to 6 V


Text in Illustration
*a Component with harness connected
(Radio and Display Receiver Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
a.

Disconnect the H51 radio and display receiver assembly connector.


b.

Disconnect the W7 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H51-4 (MACC) - W7-11 (MACC) Always Below 1 Ω
H51-5 (MIN+) - W7-12 (MCO+) Always Below 1 Ω
H51-19 (MIN-) - W7-13 (MCO-) Always Below 1 Ω
H51-6 (SNS2) - W7-14 (SNS2) Always Below 1 Ω
H51-4 (MACC) - Body ground Always 10 kΩ or higher
H51-5 (MIN+) - Body ground Always 10 kΩ or higher
H51-19 (MIN-) - Body ground Always 10 kΩ or higher
H51-18 (SGND) - Body ground Always 10 kΩ or higher
H51-6 (SNS2) - Body ground Always 10 kΩ or higher




OK

3.CHECK TELEPHONE MICROPHONE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).




OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG