Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST ECU (for LHD) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261003 PARKING ASSIST ECU(for LHD) A

PARK ASSIST / MONITORING  PARKING ASSIST ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55317A 5.REMOVE INSTRUMENT SIDE PANEL RH

Hide 55461A 6.REMOVE INSTRUMENT PANEL ORNAMENT

Hide 55607 7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55550 8.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 86792C 9.REMOVE PARKING ASSIST ECU

B356820

a.

Disconnect each connector.


b.

Remove the 2 bolts and parking assist ECU.