Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261011 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A47  Steering Angle Sensor  


DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the spiral cable sub-assembly via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1A47 A fail flag is transmitted from the steering sensor
·

Spiral cable sub-assembly

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


PROCEDURE

1.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

NG

2.REPLACE SPIRAL CABLE SUB-ASSEMBLY
2.REPLACE SPIRAL CABLE SUB-ASSEMBLY
a.

Replace the spiral cable sub-assembly with a new or normally functioning one (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).



NEXT

3.CHECK DTC
3.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor LH (master) B
DTC is output from the blind spot monitor sensor RH (slave) C



A

END (SPIRAL CABLE SUB-ASSEMBLY IS DEFECTIVE)

B

C