This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AB8 | The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU). | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
Check for CAN Communication System DTCs.
for LHD with Entry and Start System: Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Entry and Start System: Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Entry and Start System: Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD without Entry and Start System: Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD with Entry and Start System) | B |
| NG (for LHD without Entry and Start System) | C |
| NG (for RHD with Entry and Start System) | D |
| NG (for RHD without Entry and Start System) | E |
A
B
C
D
E
Replace the main body ECU (multiplex network body ECU) with a new or normally functioning one.
NEXT
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor LH (master) | B |
| DTC is output from the blind spot monitor sensor RH (slave) | C |
A
B
C