Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type) › 2015.06–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261012 REAR VIEW MONITOR SYSTEM(for Radio and Display Type) C

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Radio and Display Type)  C1622  Open or Short Circuit in Back Camera Signal  


DESCRIPTION

This DTC is stored if the radio and display receiver assembly judges as a result of its self check that the signals or signal lines between the radio and display receiver assembly and the rear television camera assembly are not normal.

DTC Code DTC Detection Condition Trouble Area
C1622 Open or Short Circuit in television camera signal
·

Harness or connector

·

Rear television camera assembly

·

Radio and display receiver assembly



WIRING DIAGRAM

E286150E04
5.603,2.651 5.915,2.805 0.312,0.154 10 H50 4.959,2.332 5.271,2.537 0.312,0.206 10 * 5.47,2.123 5.782,2.278 0.312,0.154 10 23 5.47,1.695 5.782,1.849 0.312,0.154 10 24 5.47,1.208 5.782,1.362 0.312,0.154 10 12 5.47,0.737 5.782,0.891 0.312,0.154 10 11 1.549,2.123 1.861,2.278 0.312,0.154 10 5 1.549,1.695 1.861,1.849 0.312,0.154 10 2 1.549,1.208 1.861,1.362 0.312,0.154 10 3 1.549,0.737 1.861,0.891 0.312,0.154 10 6 5.73,2.219 6.173,2.374 0.443,0.154 10 CGND 5.73,1.791 6.042,1.945 0.312,0.154 10 V- 5.73,1.304 6.042,1.458 0.312,0.154 10 V+ 5.73,0.833 6.042,0.987 0.312,0.154 10 CA+ 1.04,2.219 1.474,2.374 0.434,0.154 10 CGND 1.191,1.791 1.503,1.945 0.312,0.154 10 CV- 1.177,1.304 1.489,1.458 0.312,0.154 10 CV+ 1.177,0.833 1.489,0.987 0.312,0.154 10 CB+ 4.4,2.332 4.712,2.486 0.312,0.154 10 * 3.847,2.332 4.159,2.486 0.312,0.154 10 * 3.27,2.332 3.582,2.486 0.312,0.154 10 * 2.719,2.332 3.031,2.486 0.312,0.154 10 * 2.187,2.332 2.499,2.486 0.312,0.154 10 * 5.603,2.802 6.887,3.151 1.285,0.349 10 Radio and Display Receiver Assembly 0.363,2.651 1.527,2.805 1.164,0.154 10 X9*1, v2*2 0.363,2.802 1.658,3.129 1.295,0.327 10 Rear Television Camera Assembly 0.153,3.498 1.001,3.640 0.848,0.142 10 *: Shielded 1.414,3.498 2.699,3.640 1.285,0.142 10 *1: w/ Tire Carrier 3.095,3.498 4.380,3.640 1.285,0.142 10 *2: w/o Tire Carrier

PROCEDURE

1.CHECK FOR DTC

A

B

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the H50 radio and display receiver assembly connector.


b.

Disconnect the X9*1 or v2*2 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
w/ Tire Carrier:
Tester Connection Condition Specified Condition
H50-11 (CA+) - X9-6 (CB+) Always Below 1 Ω
H50-12 (V+) - X9-3 (CV+) Always Below 1 Ω
H50-23 (CGND) - X9-5 (CGND) Always Below 1 Ω
H50-24 (V-) - X9-2 (CV-) Always Below 1 Ω
H50-11 (CA+) - Body ground Always 10 kΩ or higher
H50-12 (V+) - Body ground Always 10 kΩ or higher
H50-23 (CGND) - Body ground Always 10 kΩ or higher
H50-24 (V-) - Body ground Always 10 kΩ or higher

w/o Tire Carrier:
Tester Connection Condition Specified Condition
H50-11 (CA+) - v2-6 (CB+) Always Below 1 Ω
H50-12 (V+) - v2-3 (CV+) Always Below 1 Ω
H50-23 (CGND) - v2-5 (CGND) Always Below 1 Ω
H50-24 (V-) - v2-2 (CV-) Always Below 1 Ω
H50-11 (CA+) - Body ground Always 10 kΩ or higher
H50-12 (V+) - Body ground Always 10 kΩ or higher
H50-23 (CGND) - Body ground Always 10 kΩ or higher
H50-24 (V-) - Body ground Always 10 kΩ or higher




OK

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
U170706E02
0.948,1.25 0.698,1.5 0.698,1.5 0.49,1.5 false 1.104,1.01 0.865,0.469 0.865,0.469 0.656,0.469 false 1.083,1.25 0.938,1.875 0.938,1.875 0.813,1.875 false 1.594,0.292 2.042,0.458 0.448,0.167 10 false H50 0.365,1.781 0.854,1.979 0.49,0.198 10 false CGND 0.281,1.406 0.521,1.604 0.24,0.198 10 false V- 0.042,0 0.281,0.198 0.24,0.198 10 false *a 0.333,0.385 0.656,0.583 0.323,0.198 10 false CA+

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H50-23 (CGND) - Body ground Always Below 1 Ω
H50-24 (V-) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H50-11 (CA+) - Body ground Ignition switch ON 5.5 to 7.05 V



Text in Illustration
*a Component with harness connected
(Radio and Display Receiver Assembly)

Result
Result Proceed to
OK A
NG (w/ Navigation System) B
NG (w/o Navigation System) C


A

4.CHECK REAR TELEVISION CAMERA ASSEMBLY

B

C

4.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Using an oscilloscope, check the waveform.

U170683E01
0.093,0.705 0.331,0.874 0.238,0.169 10 V+ 0.072,0.105 0.310,0.274 0.238,0.169 10 *a 2.286,0.105 2.524,0.274 0.238,0.169 10 *b 2.342,2.333 2.580,2.502 0.238,0.169 10 *d 4.836,0.105 5.074,0.274 0.238,0.169 10 *c 2.023,1.326 2.427,1.495 0.404,0.169 10 GND 1.028,0.724 1.432,0.893 0.404,0.169 10 H50 4.6,1.326 5.005,1.495 0.404,0.169 10 GND 0.062,1.966 0.526,2.135 0.464,0.169 10 CGND 0.581,1.311 0.498,0.767 0.498,0.767 0.337,0.767 false 0.581,1.311 0.498,0.767 0.498,0.767 0.337,0.767 false 0.693,1.48 0.61,2.028 0.61,2.028 0.519,2.028 false 0.693,1.48 0.61,2.028 0.61,2.028 0.519,2.028 false 2.795,1.858 2.711,2.406 2.711,2.406 2.551,2.406 false 2.795,1.858 2.711,2.406 2.711,2.406 2.551,2.406 false 3.182,2.333 3.421,2.502 0.238,0.169 10 *e 2.915,1.76 2.999,2.406 2.999,2.406 3.159,2.406 false 2.915,1.76 2.999,2.406 2.999,2.406 3.159,2.406 false 4.99,2.333 5.228,2.502 0.238,0.169 10 *d 5.429,1.718 5.359,2.406 5.359,2.406 5.199,2.406 false 5.429,1.718 5.359,2.406 5.359,2.406 5.199,2.406 false 5.83,2.333 6.069,2.502 0.238,0.169 10 *e 5.563,1.662 5.647,2.406 5.647,2.406 5.807,2.406 false 5.563,1.662 5.647,2.406 5.647,2.406 5.807,2.406 false

Text in Illustration
*a Component with harness connected
(Radio and Display Receiver Assembly)
*b Waveform 1
*c Waveform 2 *d Synchronized Signal
*e Video Waveform - -

Measurement Condition
Item Content
Tester Connection H50-12 (V+) - H50-23 (CGND)
Tool Setting 200 mV/DIV., 50 μs/DIV.
Condition

Waveform 1: Ignition switch ON, camera lens not covered, displaying an image

Waveform 2: Ignition switch ON, camera lens covered, blacking out screen



OK:

Waveform is as shown in illustration.


HINT:

The video waveform changes according to the image sent by the rear television camera assembly.




OK

NG

5.REPLACE REAR TELEVISION CAMERA ASSEMBLY
5.REPLACE REAR TELEVISION CAMERA ASSEMBLY

NEXT

6.CHECK FOR DTC
6.CHECK FOR DTC

A

END (REAR TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE)

B

C