Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › WIDE VIEW FRONT MONITOR SYSTEM › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261014 WIDE VIEW FRONT MONITOR SYSTEM C

PARK ASSIST / MONITORING  WIDE VIEW FRONT MONITOR SYSTEM  C1681  Front Camera Feedback Malfunction  C1682  Front Camera Current Malfunction  


DESCRIPTION

DTC C1681 is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the front television camera assembly to the parking assist ECU.

DTC C1682 is stored if the parking assist ECU judges as a result of its self check that there is a problem with the current supplied from the front television camera assembly connected to the parking assist ECU.

DTC Code DTC Detection Condition Trouble Area
C1681 Front television camera power supply failure
·

Harness or connector

·

Front television camera assembly

·

Parking assist ECU


C1682 An open or short in the front television camera signal circuit

WIRING DIAGRAM

E285856E05
2.521,2.354 3.042,2.49 0.521,0.135 10 false * 4.5,2.354 5.021,2.49 0.521,0.135 10 false * 1.219,0.781 1.76,0.958 0.542,0.177 10 false BCB+ 1.219,1.24 1.729,1.396 0.51,0.156 10 false BCV+ 1.229,1.698 1.781,1.854 0.552,0.156 10 false BCV- 1.208,2.177 1.771,2.344 0.563,0.167 10 false BGND 1.719,0.698 2.104,0.917 0.385,0.219 10 false 1 1.719,1.177 2.177,1.438 0.458,0.26 10 false 2 1.719,1.625 2.135,1.813 0.417,0.188 10 false 4 1.719,2.094 2.156,2.344 0.438,0.25 10 false 3 5.354,0.698 5.583,0.865 0.229,0.167 10 false 11 5.344,1.146 5.625,1.323 0.281,0.177 10 false 12 5.354,1.625 5.625,1.802 0.271,0.177 10 false 36 5.354,2.083 5.667,2.25 0.313,0.167 10 false 35 5.667,0.75 6.115,0.927 0.448,0.177 10 false BCB+ 5.667,1.219 6.063,1.396 0.396,0.177 10 false BCV+ 5.667,1.698 6.094,1.875 0.427,0.177 10 false BCV- 5.667,2.177 6.135,2.375 0.469,0.198 10 false BGND 0.094,2.625 0.552,2.802 0.458,0.177 10 false A52 0.104,2.792 2.323,3.021 2.219,0.229 10 false Front Television Camera Assembly 0.229,3.406 1.219,3.604 0.99,0.198 10 false *: Shielded 5.469,2.604 5.823,2.771 0.354,0.167 10 false I7 5.458,2.781 6.802,3.083 1.344,0.302 10 false Parking Assist ECU

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as wide view front monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>CALIBRATION).



PROCEDURE

1.CHECK FOR DTC


Result
Result Proceed to
DTC C1681 and C1682 are not output A
DTC C1681 and/or C1682 is output B


A

B

2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - FRONT TELEVISION CAMERA ASSEMBLY AND BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - FRONT TELEVISION CAMERA ASSEMBLY AND BODY GROUND)
a.

Disconnect the I6 and I7 parking assist ECU connectors.


b.

Disconnect the A52 front television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I7-36 (BCV-) - A52-4 (BCV-) Always Below 1 Ω
I7-12 (BCV+) - A52-2 (BCV+) Always Below 1 Ω
I7-35 (BGND) - A52-3 (BGND) Always Below 1 Ω
I7-11 (BCB+) - A52-1 (BCB+) Always Below 1 Ω
I7-36 (BCV-) - Body ground Always 10 kΩ or higher
I7-12 (BCV+) - Body ground Always 10 kΩ or higher
I7-35 (BGND) - Body ground Always 10 kΩ or higher
I7-11 (BCB+) - Body ground Always 10 kΩ or higher




OK

3.CHECK PARKING ASSIST ECU (BCB+, BGND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK PARKING ASSIST ECU (BCB+, BGND)
a.
U149425E04
1.302,1.146 1.417,1.417 1.417,1.417 1.667,1.417 true 1.333,0.979 1.167,0.667 1.167,0.667 0.917,0.667 false 0.052,0.01 0.229,0.188 0.177,0.177 10 false *a 0.5,0.583 1,0.75 0.5,0.167 10 false BCB+ 1.625,0.406 1.896,0.583 0.271,0.177 10 false I7 1.75,1.333 2.188,1.51 0.438,0.177 10 false BGND

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I7-35 (BGND) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I7-11 (BCB+) - I7-35 (BGND) Engine switch on (IG), wide view front and side monitor switch on 5.5 to 7.05 V



Text in Illustration
*a Component with harness connected
(Parking Assist ECU)

Result
Proceed to Result
OK A
NG (for LHD) B
NG (for RHD) C


A

4.CHECK FRONT TELEVISION CAMERA ASSEMBLY (BCV+, BGND)

B

C

4.CHECK FRONT TELEVISION CAMERA ASSEMBLY (BCV+, BGND)
a.

Measure the resistance according to the value(s) in the table below.

E348793E06
0.76,0.302 1.188,0.531 0.427,0.229 0.677,1 0.667,0.5 0.667,0.5 0.5,0.5 true 1.083,1.333 0.833,1.333 0.833,1.333 0.698,1.104 true 4.115,2.188 3.906,2.188 3.906,2.188 3.833,1.615 false 4.344,2.01 4.177,2.01 4.177,2.01 3.948,1.563 false 6.24,2.125 6.031,2.125 6.031,2.125 5.958,1.458 false 6.531,1.969 6.365,1.969 6.365,1.969 6.083,1.406 false 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a 3.271,0.167 3.583,0.365 0.313,0.198 10 false *b 5.406,0.146 5.719,0.344 0.313,0.198 10 false *c 3.104,1.052 3.448,1.25 0.344,0.198 10 false GND 5.156,1.042 5.5,1.24 0.344,0.198 10 false GND 4.156,2.115 4.469,2.313 0.313,0.198 10 false *d 6.281,2.042 6.594,2.24 0.313,0.198 10 false *d 4.385,1.917 4.698,2.115 0.313,0.198 10 false *e 6.604,1.896 6.917,2.094 0.313,0.198 10 false *e 0.104,0.406 0.573,0.594 0.469,0.188 10 false BCV+ 1.156,1.25 1.625,1.49 0.469,0.24 10 false BGND 0.927,0.333 1.24,0.531 0.313,0.198 10 false I7

Text in Illustration
*a Component with harness connected
(Parking Assist ECU)
*b Waveform A
*c Waveform B *d Synchronized Signal
*e Video Waveform - -

HINT:
·

A waterproof connector is used for the front television camera assembly. Therefore, inspect the waveform at the parking assist ECU with the connector connected.

·

The video waveform changes according to the image sent by the front television camera assembly.



OK:

Waveform is as shown in the illustration.


Item Content
Terminal No. (Symbol) I7-12 (BCV+) - I7-35 (BGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition
·

Waveform A: Engine switch on (IG), wide view front and side monitor switch on and camera lens is not covered, displaying an image

·

Waveform B: Engine switch on (IG), wide view front and side monitor switch on and camera lens is covered, blacking out the screen




Result
Proceed to Result
OK (for LHD) A
OK (for RHD) B
NG C


A

B

C