1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
62111C
4.REMOVE COWL SIDE TRIM BOARD RH
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH
55480D
6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55476C
7.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH
55607
8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55045
9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
73900
10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
82730A
11.REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
86792C
12.REMOVE PARKING ASSIST ECU
Disconnect the 3 connectors.
Remove the 2 bolts and parking assist ECU.