Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261015 PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)  ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the parking assist monitor system and side monitor system.

HINT:
·

The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.

·

for Navigation Receiver Type:

If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.

·

for Radio and Display Type:

If the parking assist ECU does not operate due to a power source problem, an audio and visual system DTC may be stored due to an AVC-LAN communication interruption.

·

If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.



WIRING DIAGRAM

E348792E03
0.792,0.625 1.625,0.875 0.833,0.25 10 false from Battery 2.552,0.802 3.385,1.052 0.833,0.25 10 false ECU-B 4.906,1.344 5.74,1.594 0.833,0.25 10 false GND1 4.896,0.635 5.177,0.844 0.281,0.208 10 false +B 4.708,0.521 4.99,0.729 0.281,0.208 10 false 1 4.708,1.208 4.99,1.417 0.281,0.208 10 false 4 4.781,1.865 5.063,2.073 0.281,0.208 10 false I6 4.781,2.052 6.125,2.271 1.344,0.219 10 false Parking Assist ECU

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK FOR DTC (NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM)

b.

Check for DTCs.


OK:

DTC B15D8 is not output.


HINT:

The parking assist ECU is connected to the navigation receiver assembly*1 or radio and display receiver assembly*2 by AVC-LAN communication line. DTC B15D8 may be stored to the navigation receiver assembly*1 or radio and display receiver assembly*2 due to the power source condition or changes in the power supply waveform for the parking assist ECU, even though there is no problem with the AVC-LAN communication system.

*1: for Navigation Receiver Type

*2: for Radio and Display Type




Result
Result Proceed to
OK A
NG (for Navigation Receiver Type) B
NG (for Radio and Display Type) C


A

2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)

B

C

2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)
a.
U149417E02
2.51,0.969 2.708,0.531 2.708,0.531 2.865,0.531 true 0.865,0.979 0.573,0.563 0.573,0.563 0.396,0.563 true 1.615,0.281 1.896,0.448 0.281,0.167 10 false I6 2.917,0.438 3.344,0.604 0.427,0.167 10 false GND1 0.177,0.479 0.438,0.667 0.26,0.188 10 false +B 0.021,0.021 0.271,0.208 0.25,0.188 10 false *a

Disconnect the I6 parking assist ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I6-4 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I6-1 (+B) - I6-4 (GND1) Always 10 to 16 V



Text in Illustration
*a Front view of wire harness connector
(to Parking Assist ECU)


OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR