This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1626 | A fail flag is transmitted from the spiral with sensor cable sub-assembly | ·
Spiral with sensor cable sub-assembly ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Replace the spiral with sensor cable sub-assembly with a new or known good one (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).
NEXT
Check for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>DTC CHECK / CLEAR).
| Proceed to | Result |
|---|---|
| DTC C1626 is not output | A |
| DTC C1626 is output (w/ Tire Carrier) | B |
| DTC C1626 is output (w/o Tire Carrier) | C |
A
B
C