Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45100
3.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).
45287
4.REMOVE LOWER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
Remove the lower steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL).
for Power Tilt and Power Telescopic Steering Column:
Remove the lower steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>REMOVAL).
45286B
5.REMOVE UPPER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
Remove the upper steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL).
for Power Tilt and Power Telescopic Steering Column:
Remove the upper steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>REMOVAL).
84306
6.REMOVE SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the spiral cable sub-assembly.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the 3 claws and remove the spiral cable sub-assembly.
Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.
Do not rotate the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.
Make sure the steering wheel assembly is installed and centered before rotating the steering sensor when performing steering sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
Do not remove the steering sensor from the spiral cable sub-assembly.