Home › Power Source / Network › 1KD-FTV (BATTERY / CHARGING) › GENERATOR › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053726 1KD-FTV BATTERY / CHARGING _0261023 GENERATOR A

1KD-FTV BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT

a.

Remove the fan and generator V belt (See page Engine / Hybrid System>1KD-FTV (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


Hide 17801 5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 27020 8.REMOVE GENERATOR

a.
A222880

Disconnect the generator connector.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the generator wire.


d.

Remove the 2 bolts and generator.