Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › CHARGING SYSTEM › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261025 CHARGING SYSTEM C

1GD-FTV BATTERY / CHARGING  CHARGING SYSTEM  P161A  LIN Communication Error with Alternator  


DESCRIPTION

The ECM and generator assembly each detect reception malfunctions. A generator assembly reception malfunction detected by the generator assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or generator assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC.

DTC Code DTC Detection Condition Trouble Area
P161A Diagnosis condition:
Engine switch on (IG)
When the ECM cannot receive LIN communication, the generator assembly cannot receive LIN communication for approximately 17 minutes or more
Other: 1 trip
·

Harness or connector

·

Generator assembly

·

ECM



WIRING DIAGRAM

E221308E28
1.792,0.833 2.25,1.031 0.458,0.198 10 false 2 0.667,1.833 1.125,2.031 0.458,0.198 10 false C157 1.458,1.021 1.917,1.219 0.458,0.198 10 false LIN 0.667,2.01 2,2.26 1.333,0.25 10 false Generator Assembly 5.375,0.833 5.833,1.031 0.458,0.198 10 false 29 5.667,1.031 6.125,1.229 0.458,0.198 10 false LIN 5.823,1.854 6.281,2.052 0.458,0.198 10 false C152 5.833,2.031 6.292,2.229 0.458,0.198 10 false ECM 0.917,2.354 2.542,2.552 1.625,0.198 10 false : LIN Communication Line

PROCEDURE

1.CHECK CHARGING SYSTEM

OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
a.

Disconnect the C152 ECM connector.


b.

Disconnect the C157 generator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
C152-7 (LIN) - C157-2 (LIN) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
C152-7 (LIN) or C157-2 (LIN) - Body ground Engine switch off (while LIN communication is stopped) 10 kΩ or higher



d.

Reconnect the C157 generator assembly connector.


e.

Reconnect the C152 ECM connector.



OK

3.INSPECT GENERATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT GENERATOR ASSEMBLY
a.

Inspect the generator assembly.


Result
Result Proceed to
OK A
NG (for 100 A Type) B
NG (for 130 A Type) C



A

B

C