1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
(See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)
74481
3.REMOVE BATTERY HOLD DOWN CLAMP
Loosen the 2 nuts.
Remove the 2 battery clamp bolts and battery hold down clamp.
28800
4.REMOVE BATTERY
74431
5.REMOVE BATTERY TRAY
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17342F
7.REMOVE NO. 2 INTERCOOLER AIR HOSE
16361A
8.REMOVE FAN AND GENERATOR V BELT
27060
9.REMOVE GENERATOR ASSEMBLY
Disconnect the connector from the generator assembly.
Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and disconnect the wire harness from the generator assembly.
Detach the clamp and disconnect the wire harness from the generator bracket.
Remove the 2 bolts and generator assembly.
Remove the bolt and generator bracket from the generator assembly.